Zenith CH750 CruZer Elevator Trim Cable Fairing

$19.90

This fairing allows to run the cable inside of a Zenith CH750 CruZer’s elevator and to pass it through the spar right next to the fuselage, while also providing a clean look.

Easy to install, print template included.

Designed and made in the USA. Sealed 3D print.

Description

Zenith uses a rubber grommet to pass the elevator trim cable of their Zenith CH750 CruZer kits through the elevator’s forward spar and then runs the cable along the spar towards the fuselage.

Our fairing allows to run the cable inside of the elevator and to pass it through the spar right next to the fuselage, while also providing a clean look.

Note: The fairing is 3D printed with this inside facing down. The printing process causes the inside of the to fairing to be somewhat rough. This does however not impact the function and will not be visible anymore, once the elevator is closed.

The fairings are sealed for increased strength, a smooth finish and, most importantly, to make them easy to paint.

Included in the kit:

  • 1x Fairing, white, sealed
  • 1x Drill template
  • 5x 3/32″ rivets, made for a material thickness of 0.032″-0.125″
  • 5x 3/32″ washers, to keep the rivets from pulling through the plastic

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.